If directed by Replibit to restore the Dell Optiplex, please follow the procedures below:
1. Login into the Appliance.
2. Choose the snapshot you want to recover from, and mount as iSCSI in test mode. (Please verify first that the snapshot is good and will boot as a VM on the Appliance).
4. Start up the machine that needs to be recovered with the Replibit Recovery iso. You can download the Replibit Recovery Toolkit from this link: http://www.efolder.net/downloads/
5. Once booted into the recovery environment, and connected to the network:
- Click on the Launch button in the lower left hand corner
- Open iSCSI Initiator
- Connect to the Appliance using the Appliance's IP address
- Connect the partition(s)
6. Next, open LX Terminal in the Launch Menu. This will open the Linux shell.
7. Type in sudo parted -l to list all the volumes visible to the environment.
- Internal drives will usually be listed first
- for example: /dev/sda, ./dev/sdb.. ect with the iSCSI volumes from the mounted snapshot listed after that
8. Used the "dd" command to do a direct, sector by sector, copy from the disk image on iSCSI to the computer's internal disk.
- for example: dd if=/dev/sdx of=/dev/sda bs=4096 (use parted to guide which is the iSCSI drive, and which is your drive, if=(this is your iSCSI drive) of=(this is your destination drive))
*WARNING*: This is only required when an error happens in the recovery. You may need to use the "sudo" command in front of "dd" if it errors with does not have permission.